高压下β-InSe弹性常数、电子结构的第一性原理研究

基于密度泛函理论的第一性原理计算方法,本文研究了高压对β-InSe弹性常数、机械性能和电子结构的影响.在0～20 GPa范围内,随着压力的增大,β-InSe的晶格常数、晶胞体积逐渐减小,结构参数a/a_0、c/c_0、V/V_0单调减小.在0～12 GPa范围内,弹性模量G、E、B和泊松比v随着压力增大而增大,在16 GPa时大幅减小,G、E、B分别减小了34.9%、53.3%、82.9%.随着压力增大,Se-In和In-In原子之间的电荷密度增大,Se-In原子之间的共价键增强,层间距减小.而且,β-InSe在20 GPa时带隙消失,发生了半导体向半金属的相变.     

基质刚性影响声孔效应介导的单细胞基因转染

实验研究了基质刚性对单细胞质粒DNA转染效果的影响。实验采用高声压短脉冲(0.45MPa,10μs)条件的超声对培养在不同硬度凝胶基质(软的凝胶基质：0.2kPa,硬的凝胶基质：40kPa)上的力学敏感细胞NIH 3T3进行质粒DNA转染实验。实验结果表明,培养在硬的凝胶基质上的细胞,质粒DNA转染效率明显高于培养在软的凝胶基质上的细胞。进一步对质粒DNA进行荧光示踪可知培养在不同刚性基质上的细胞导入质粒DNA的方式不同。当细胞被培养在硬的凝胶基质上时,通过声致穿孔产生的小孔进入细胞内的质粒DNA更多,而培养在软的凝胶基质上的细胞,更多的质粒DNA可以通过非声致穿孔作用,例如内吞方式导入细胞。 细胞骨架蛋白分布规律表明,硬的凝胶基质上培养的细胞内有更多的F肌动蛋白微丝,可以更好地支撑起细胞的铺展形态,相对不容易发生内吞作用。而软的凝胶基质上培养的细胞内F肌动蛋白则更多以球形状态存在,细胞形貌骗向圆形,此时更容易发生胞吞作用。     

A molecular fluorophore in citric acid/ethylenediamine carbon dots identified and quantified by multinuclear solid-state nuclear magnetic resonance

The composition of fluorescent polymer nanoparticles, commonly referred to as carbon dots, synthesized by microwave-assisted reaction of citric acid and ethylenediamine was investigated by ¹³C, ¹³C{¹H}, ¹H─¹³C, ¹³C{¹⁴N}, and ¹⁵N solid-state nuclear magnetic resonance (NMR) experiments. ¹³C NMR with spectral editing provided no evidence for significant condensed aromatic or diamondoid carbon phases. ¹⁵N NMR showed that the nanoparticle matrix has been polymerized by amide and some imide formation. Five small, resolved ¹³C NMR peaks, including an unusual ═CH signal at 84 ppm (¹H chemical shift of 5.8 ppm) and ═CN₂ at 155 ppm, and two distinctive ¹⁵N NMR resonances near 80 and 160 ppm proved the presence of 5-oxo-1,2,3,5-tetrahydroimidazo[1,2-a]pyridine-7-carboxylic acid (IPCA) or its derivatives. This molecular fluorophore with conjugated double bonds, formed by a double cyclization reaction of citric acid and ethylenediamine as first shown by Y. Song, B. Yang, and coworkers in 2015, accounts for the fluorescence of the carbon dots. Cross-peaks in a ¹H─¹³C HETCOR spectrum with brief ¹H spin diffusion proved that IPCA is finely dispersed in the polyamide matrix. From quantitative ¹³C and ¹⁵N NMR spectra, a high concentration (18 ± 2 wt%) of IPCA in the carbon dots was determined. A pronounced gradient in ¹³C chemical-shift perturbations and peak widths, with the broadest lines near the COO group of IPCA, indicated at least partial transformation of the carboxylic acid of IPCA by amide or ester formation.     

Lipase‐Supported Metal–Organic Framework Bioreactor Catalyzes Warfarin Synthesis

A green and sustainable strategy synthesizes clinical medicine warfarin anticoagulant by using lipase‐supported metal–organic framework (MOF) bioreactors (see scheme). These findings may be beneficial for future studies in the industrial production of chemical, pharmaceutical, and agrochemical precursors.     

Polymer nanoparticles with a sensitive CO2‐responsive hydrophilic/hydrophobic surface

Poly(methyl methacrylate) (PMMA) nanoparticles with a sensitive CO₂‐responsive hydrophilic/hydrophobic surface that confers controlled dispersion and aggregation in water were prepared by emulsion polymerization at 50 °C under CO₂ bubbling using amphiphilic diblock copolymers of 2‐dimethylaminoethyl methacrylate (DMAEMA) and N‐isopropyl acrylamide (NIPAAm) as an emulsifier. The amphiphilicity of the hydrophobic–hydrophilic diblock copolymer at 50 °C was triggered by CO₂ bubbling in water and enabled the copolymer to serve as an emulsifier. The resulting PMMA nanoparticles were spherical, approximately 100 nm in diameter and exhibited sensitive CO₂/N₂‐responsive dispersion/aggregation in water. Using copolymers with a longer PNIPAAm block length as an emulsifier resulted in smaller particles. A higher concentration of copolymer emulsifier led to particles with a stickier surface. Given its simple preparation and reversible CO₂‐triggered amphiphilic behavior, this newly developed block copolymer emulsifier offers a highly efficient route toward the fabrication of sensitive CO₂‐stimuli responsive polymeric nanoparticle dispersions. © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2019, 57, 2149–2156     

光寻址电位传感器的正交相位检波检测方法

光寻址电位传感器的幅度检测方法易受噪声干扰,灵敏度差,信噪比和精度低,且受调制光源的影响较大,影响检测结果的准确性.为此提出了一种基于正交相位检波的光寻址电位传感器检测方法.该方法是将光寻址电位传感器的输出光电流信号分别与两路正交信号相乘,通过低通滤波提取直流分量并相除,即可得到光寻址电位传感器的输出信号相位信息.与已有的光寻址电位传感器相位检测方法相比,该方法具有算法复杂度低、实时性高的优点.实验研究了调制光源光强对光寻址电位传感器幅度检测和相位检测的影响,对比分析了光寻址电位传感器的传统幅度检测方法与正交相位检波检测方法对pH检测的灵敏度、线性度及信噪比.结果表明,相比于幅度检测方法,调制光源光强对光寻址电位传感器的相位检测影响更小,在频率为10 kHz,pH的范围为1.68~10.01的情况下,相位检测方法比幅度检测方法测得的灵敏度增加了7 mV/pH,精度提高了14.9 mpH,非线性误差减小了0.003%,均方差减少了0.1051×10^-5,信噪比增加了8.2827 dB.该方法特别适用于弱光下的光寻址电位传感器检测.     

Evaluation of Charged Defect Energy in Two-Dimensional Semiconductors for Nanoelectronics: The WLZ Extrapolation Method

Defects play a central role in controlling the electronic properties of two-dimensional (2D) materials and realizing the industrialization of 2D electronics. However, the evaluation of charged defects in 2D materials within first-principles calculation is very challenging and has triggered a recent development of the WLZ (Wang, Li, Zhang) extrapolation method. This method lays the foundation of the theoretical evaluation of energies of charged defects in 2D materials within the first-principles framework. Herein, the vital role of defects for advancing 2D electronics is discussed, followed by an introduction of the fundamentals of the WLZ extrapolation method. The ionization energies (IEs) obtained by this method for defects in various 2D semiconductors are then reviewed and summarized. Finally, the unique defect physics in 2D dimensions including the dielectric environment effects, defect ionization process, and carrier transport mechanism captured with the WLZ extrapolation method are presented. As an efficient and reasonable evaluation of charged defects in 2D materials for nanoelectronics and other emerging applications, this work can be of benefit to the community.     

Optical Trapping with Focused Surface Waves

Near-field optical trapping can be realized with focused evanescent waves that are excited at the water–glass interface due to the total internal reflection, or with focused plasmonic waves excited on the water–gold interface. Herein, the performance of these two kinds of near-field optical trapping techniques is compared using the same optical microscope configuration. Experimental results show that only a single-micron polystyrene bead can be trapped by the focused evanescent waves, whereas many beads are simultaneously attracted to the center of the excited region by focused plasmonic waves. This difference in trapping behavior is analyzed from the electric field intensity distributions of these two kinds of focused surface waves and the difference in trapping behavior is attributed to photothermal effects due to the light absorption by the gold film.     

语音通信降噪研究

语音通信系统中，语音通过信道传输将不可避免地引入码间串扰和信号畸变，同时受到噪声污染。本文在分析自适应盲均衡算法CMA(constant modulus algorithm）和改进盲均衡算法的基础上，考虑到自适应盲均衡技术在语音噪声控制方面能力有限，将自适应盲均衡技术与小波包掩蔽阈值降噪算法联合使用，形成一种基带语音增强新方法。仿真试验结果显示自适应盲均衡技术可以使星座图变得清晰而紧凑，有效减小误码率。研究证实该方法在语音信号ISI和畸变严重情况下，在白噪及有色噪声不同的噪声环境中都具有稳定的降噪能力，消噪同时可获得汉语普通话良好的听觉效果。     

不同声音偏好的游客声景观主观评价差异——以丽江大研古镇为例*

古镇作为集自然景观与人文景观一体的景区，具有丰富的声音类型。本研究以大研古镇为例，通过实地调研探究不同声音偏好的游客对古镇声景观的主观评价差异。基于游客的声音偏好，将游客分为偏爱自然声和偏爱人工声两大类。通过因子分析提取游客声景观主观评价的5个主因子：大小、音质、效价、偏好和唤醒。进一步分析发现，这5个因子具有一定的层级性，其中从大小到唤醒代表声景观评价从声音的物理属性向声音的联想评价逐级提升。其中在低层级评价(大小、音质)中，偏好自然声的游客和偏好人工声的游客无显著差异，低层级评价具有稳定性；而在高层级评价(效价、偏好和唤醒)中，偏好人工声的游客更关注古镇声景观的淳朴性和遗产性。因此，游客对声景观的主观评价可视为一种指标，判断景区声景所处的评价阶段，从而为景区声景观改善提供更有针对性的建议。